Intellinet 523868, Руководство пользователя

Страница: 23 / 56

Priority: This is to set the port priority in the switch. Here, a low value indicates a high priority.
The port with the lower priority is more likely to be blocked by STP if a network loop is
detected. The valid range is 0 – 255.
Link Type: By default, the link type is determined from the duplex mode of the interface: A full-
duplex port is considered to have a point-to-point connection; a half-duplex port is considered
to have a shared connection.
Edge Port: An edge port is the same as a Port Fast-enabled port, and you should enable it only
on ports that connect to a single end-station.
Click “Submit” to commit the settings. Click “Refresh” to display current switch settings. To
eventually make all changes permanent in Flash memory, click on “Save Configuration” (listed
at the bottom of the Configuration Menu) and click “Save.”
2.2.7.2 Link Aggregation Static
This screen is for configuring the link aggregation static group (port trunking). The switch provides
a maximum of 32 link aggregation groups, with the maximum achieved in a stacking configuration.
Trunk ID: This
number identifies
the trunk group in
addition to the
group name.
Port Selection
Criterion: This is
the algorithm to
distribute packets
among the ports
of the link
aggregation group
according to the
source MAC
address,
destination MAC
address, source and destination MAC address, source IP address, destination IP address,
or source and destination IP address.
23
WEb MANAgEMENT