Intel SR2600UR - Server System - 0 MB RAM, Руководство по обслуживанию

Страница: 126 / 234

106 Intel
®
Server System SR2600UR/SR2625UR Service Guide
a. Connect the hard drive SATA cables from either the server board or the add-in
card to the corresponding SATA connectors on the midplane board.
Figure 99. Installing the SATA Cables
b. If you connect the SATA cables from the passive midplane to the add-in card,
also install the 3-pin white cable between the HBA connector on the midplane
and the add-in card to enable fault LED control.
Note: Do NOT connect the HBA cable in a system with an active midplane or when
using the SATA connectors on the server board to connect the hard drive SATA
cables.
6. Install the fan module. For instructions, see “Replacing a Fan Module” on
page 127 .
7. Install the bridge board as follows:
a. Open the retention clips on both ends (see letter “A” in Figure 100 ).
b. Slide the bridge board through the fan assembly (see letter “B” in Figure 100 ).
c. Insert the bridge board into the bridge board connector on the midplane and
server board (see letter “C” in Figure 100 ).
AF003071
B
4
5
6
7
1
2
3
A
0
Passive
Midplane
Ser
ver
Board
0
3
2
1
4
5
Air Baffle