Intel R1304BTLSFAN, Руководство по обслуживанию

Страница: 66 / 112

AF003723
F
E
46 Intel
®
Server System R1304BTSSFAN/R1304BTLSFAN/R1304BTLSHBN Service Guide
Figure 26. Install Drive Assembly into the Server System (R1304BTLSHBN)
12. Install the server system cover. For instructions, see “Installing the Server System
Cover” on page 29 .
13. (Optional) Install the front bezel.
14. Plug all peripheral devices and the AC power cable into the server.
Removing a Hot-Swap SATA Drive (R1304BTLSHBN)
1. If it is installed, remove the front bezel. For instructions.
2. Press in on the green latch at the front of the hard drive carrier.
3. Pull out on the black lever to slide the carrier from the server system.
4. Remove the four screws that attach the hard drive to the drive carrier. Lift the drive
from the carrier. Store the drive in an anti-static bag.
5. If you are not installing a new drive, place the plastic retention device into the drive
carrier, using the four screws you removed from the hard drive.
6. Insert the screws that held the drive in the carrier into the screw locations on the
carrier for future use.
7. With the black lever in the fully open position, slide the drive carrier into the server
system. The green latch must be to the right. Do not push on the black lever until
the lever begins to close by itself.