Intel R1000WF Series, Руководство по системной интеграции и обслуживанию

Страница: 39 / 125

Intel ® Server System R1000WF Product Family System Integration and Service Guide
23
2.4.3 Processor Replacement
1. Remove Processor from Server Board
WARNING: Processor heat sinks can become extremely hot during normal system operation. Before
attempting to remove the processor from the server board, allow the processor heat sinks to fully cool.
Failing to follow the indicated disassembly sequence, may cause damage
Figure 35. Uninstalling the PHM
 Using a T30 Torx bit screwdriver, loosen each heat sink fastener in the sequence shown on the label
located on the top of the heat sink (see Letter
A )
 Lift the PHM straight up from the server board until it is free from the processor socket bolster plate
guide pins (see Letter
B )
Note: to prevent possible damage to the processor socket, re-install the original plastic cover to the
processor socket.
Figure 36. Plastic Processor Socket Cover Installation
2.
With the heat sink facing down, place the Processor Heat Sink Module (PHM) onto a flat non-conductive
surface