I
NTEL
® X
EON
® P
ROCESSOR
7500 S
ERIES
U
NCORE
P
ROGRAMMING
G
UIDE
UNCORE PERFORMANCE MONITORING
2-121
RETRY_MFULL
• Title: Retry MFull
• Category: Retry Events
• Event Code: 0x02, Max. Inc/Cyc: 1,
• Definition: Number of retries detected while in the "mfull" state. Also known as the “badly starved”
state.
RETRY_STARVE
• Title: Retry Starve
• Category: Retry Events
• Event Code: 0x03, Max. Inc/Cyc: 1,
• Definition: Number of retries detected while in the "starved" state.
SCHED_INFLIGHT_CMDS
• Title: Scheduler In-flight Commands
• Category: M-Box Commands Received
• Event Code: 0x1c, Max. Inc/Cyc: 1,
• Definition: Number of new scheduler commands that were accepted.
SCHED_MODE_CHANGES
• Title: Scheduling Mode Changes
• Category: DRAM Commands
• Event Code: 0x08, Max. Inc/Cyc: 1,
• Definition: Number of ISS scheduling mode transitions detected.
THERM_TRP_DN
• Title: DIMM ‘Dn’ Thermal Trip Points Crossed
• Category: Thermal Throttle
• Event Code: 0x05, Max. Inc/Cyc: 1,
• Definition: Counts when a specified thermal trip point is crossed in the “down” direction.
Extension
THR Bits
[10:9],[3]
Description
ALL.GT_MID_RISE
0x3,0x1
Advance the counter when the above mid temp thermal
trip point (rising) is crossed in the "down" direction for any
DIMM
ALL.GT_MID_FALL
0x2,0x1
Advance the counter when the above mid temp thermal
trip point (falling) is crossed in the "down" direction for any
DIMM
ALL.GT_LO
0x1,0x1
Advance the counter when the above low temp, but below
mid temp thermal trip point is crossed in the "down"
direction for any DIMM.
ALL.LT_LO
0x0,0x1
Advance the counter when the below low temp thermal trip
point is crossed in the "down" direction for any DIMM
DIMM{n}.GT_MID_RISE
0x3,0x0
Advance the counter when the above mid temp thermal
trip point (rising) is crossed in the "down" direction for
DIMM #?
NOTE: THR Bits [6:4] must be programmed with the DIMM
#
DIMM{n}.GT_MID_fALL
0x2,0x0
Advance the counter when the above mid temp thermal
trip point (falling) is crossed in the "down" direction for
DIMM #?
NOTE: THR Bits [6:4] must be programmed with the DIMM
#