System Setup and Installation
Getting Started Guide
29
Once the steps above are complete, power the Mohon Peak system off, and remove the USB
Flash drive. The system is now up to date and ready to use.
3.4
Clearing CMOS
Clearing the CMOS resets only the variables saved in the RTC registers. To clear the CMOS on
a Mohon Peak CRB, the board must be powered off completely. Once the machine is off, move
the JP12 jumper (see
) from the 1-2 position (default) to the 2-3 position (clearing
CMOS). Leave the jumper in the clearing CMOS position for two seconds, then return it to the
default position. The CMOS should now be clear and the CRB can now be booted with default
firmware settings.
§
