Integral Circuits LOCOn TROLLER LT 150 A, Руководство пользователя

Страница: 9 / 36

9
PRELIMINAR
Y
PRELIMINAR
Y
3. System startup procedure
1. Turn on the handset by pressing the power button for 2
seconds
2. Turn the Key switch on your locomotive to ON. Position.
3. The LT150 A will go through a startup sequence.
4. When all system checks are done and turn out OK, it will start
flashing the system LED indicator while the Master Relay led will
become lit solid
4.a The Locomotive Link symbol (on left of screen) will show up
5. press the brake button on the handset until the system LED
lights up solid . System, Master Relay and Radio link should be
solid
Startup Error Messages:
These error messages appear if any of the system checks at startup return a
negative result.
The controller will check for battery voltage and motor drive/motor health, before
it unlocks the system for use
Low locomotive battery error:
Symptom: Solution:
Battery voltage shows 0 Check the wire and fuse for the battery monitors
Battery voltage is ~ 22V 24V sys Locomotive batteries need recharged.
Battery voltage is ~ 33V 36V sys Locomotive batteries need recharged.
Motor test failed error:
Symptom: Solution:
Motor short detected! Check the wiring of the motors for shorts.
Check the motors directly for shorts.
Startup:
1.
2.
3.
4.
5.
all initially off
press
D
U
D
U
D
U
D
U
LOCO BATTERY LOW
Low Battery Voltage: 0.02V
D
U
D
U
D
U
D
U
MOTOR TEST FAILED
Motor short detected!
D
U
D
U
D
U
D
U
D
U
D
U
D
U
D
U
0A 25.0V 78F
Dashboard fills with Telemetry.
Locomotive Link symbol appears(left)
3 Leds Solid