9 | Integral Audio | Installation Instructions
Continued on next page...
33. I
nStall
tHe
a
MplIfIer
b
racKet
(
part
2)
Leaving the Common Ground connection in place,
put the two 6mm washers over the Common Ground
threaded stud, then the bracket, and finally the 6mm
nut. Tighten the nut using a deep 10mm socket.
Fasten the #8 X ½” Screw through the rear hole in
the bracket and into the Screw Grommet. Prevent
the Grommet from turning with a straight pick or small
screwdriver inserted into the split in the side.
39. t
Hreaded
I
nSertS
(o
VerVIew
)
Self-Sealing Threaded Inserts are used to secure
the enclosure to the vehicle. It is important that you
follow these installation steps carefully and com-
pletely. An extra Insert is provided in case you run
into trouble.
40. I
nStall
t
Hreaded
I
nSertS
(
part
1)
Using a 7/16” bit (NOT a ½” bit!), drill holes in the 2
positions marked on the boot floor. Do not let the drill
bit penetrate more than ¼” through the sheet metal.
You may find it helpful to use a cut-to-length wood
block as a stop for the drill. It is important to drill the
holes EXACTLY where they were marked.
Remove any metal burrs - the hole must have clean
edges.
38. a
ttacH
tHe
M
ountIng
b
racKetS
Remove the enclosure. Align the brackets with the
lines marked in the previous step. Place the bottom
of the bracket approx 1/4” above the bottom edge
of the enclosure. Attach the bracket with the #10 x
¾” Pan Head Screws. Replace the enclosure and
confirm hole locations are correctly market. Remove
the enclosure.
37. M
arK
for
b
racKet
p
laceMent
Temporarily replace the Rear Sill. Center the
subwoofer enclosure in the boot. Place a Mount-
ing Bracket on either side with the single-hole side
centered over the indicated raised area of the boot
floor. Keep the hole at least 3/8” away from the
edges of the raised area of the sheet metal. Cut a
notch the carpet edge if necessary. Mark the center
with a marker or center punch. Mark the location of
the vertical sides of the bracket against the enclosure
with a pencil.
36. M
ount
a
MplIfIer
Mount the Amplifier to the bracket using the (4) #6 x
3/8” screws. Use the pre-drilled hole locations. Place
the wire bundle (that was loosened earlier) in the gap
between the amp and the sheet metal.
35. a
MplIfIer
c
onnectIonS
Connect the Power, Ground, and Remote Turn-on
Lead wires to the amplifier. Connect the RCA Inter-
connects. Set the Signal input selector on the amp to
“RCA”. Connect the Speaker Wire to the Amp using
the “bridged” connection locations. Refer to the Amp
manual if needed.
34. S
peaKer
w
Ire
Cut 2 feet from the length of 16AWG Speaker Cable
and set aside. Split and strip the ends of the remain-
ing 6 feet. Attach the positive wire to the L+ connec-
tor on the amp, negative to R-. Attach the Banana
Plugs to the other end by loosening the 3mm Allen
screw, inserting the wire, and tightening the screw.
Run the Speaker Wire from the amp area to the cen-
ter of the vehicle, routing it along & under the carpet
trim at the front of the boot area.
E. INSTALL THE ENCLOSURE MOUNTS