5 | Integral Audio | Installation Instructions
Continued on next page...
1. r
eMoVe
r
ear
p
arcel
S
Helf
& f
loor
p
anel
Detach straps (1) and slide the parcel shelf out of
guides (2).
Remove the luggage compartment floor panel. The
floor panel will not be placed back into the vehicle
and can be stored.
A. PREP THE VEHICLE
7. d
etacH
r
IgHt
& l
eft
S
Ide
r
ear
p
anel
Depress latches (1) and remove cover.
Remove screws (2) and (3).
Repeat this step for the LEFT side. The left side
does not need to be removed (see next step), it just
needs to be loosened to facilitate access for mounting
the amplifier.
8. r
eMoVe
r
IgHt
S
Ide
r
ear
p
anel
Detach the rear seat belt at the bottom with a Torx
T-50. Pull the panel towards the interior of the
vehicle releasing the friction clips (2). Then lift up
on the panel, freeing it from the metal retaining clips
attached along the top of the panel (1).
Reinstallation is the reverse of the above. Guide the
panel onto the retaining clips (1) first. You may find it
easier to bend the clips open slightly.
5. r
eMoVe
r
ear
S
eat
(p
art
2)
The outside of each seat back has a pin that sits in
a “T” shaped keyway. Rotate each seat back up to
about 45 degrees and pull toward the center of the
vehicle to release.
4. r
eMoVe
r
ear
S
eat
(p
art
1)
Fold down the rear seat backs. Remove the 10mm
bolt at the base of the center attachment of the rear
seat backs. Pry the catch up. Lift up on the seat
back to release.
3. r
eMoVe
r
ear
S
Ill
Locate the three expansion rivets (1) at the lower
edge of the rear sill. Pry out the center-pin of each
expansion rivet with a flat screwdriver or panel
removal tool. Pry out the base of the expansion rivet.
Pull the bottom of the rear sill toward the front of the
vehicle to clear the metal “D” rings. Pull the whole
panel upwards, releasing the friction clips (2). Keep
the center-pins with the expansion rivets to avoid
confusion with similar pins removed in later steps.
2. r
eMoVe
f
loor
p
anel
Pry the center pin (1) out of the two retaining clips.
Remove the floor panel (2).
6. r
eMoVe
r
ear
S
eat
b
ottoM
Pull up firmly on the front of the edge of the rear seat
bottom to release. The back of the seat is attached
by wire rod loops hooked into down-ward facing tabs.
Press down on the back edge of the seat bottom and
pull forward to release .