7 | Integral Audio | Installation Instructions
Continued on next page...
17. I
nStall
f
uSe
H
older
(p
art
2)
Cut a length of Power Wire to run from the fuse
holder to the battery. Strip the length of the Power
Wire and both ends. Crimp the red 5/16” Gold Ring
Terminal to one end.
Insert the other end through one end cap of the fuse
holder and secure the gold terminal end onto the wire
with a 3mm Allen wrench. Repeat the process to
attach the other section of wire.
22. M
ount
r
eMote
l
eVel
c
ontrol
Mount the PAC LC1 Remote Level Control in the
location of your choice with the self-adhesive 3M
Dual-lock or the screws provided with the Level Con-
trol. Our preference is under the bottom of the center
console as shown.
NOTE: If using the 3M Dual-lock, wipe both surfaces
with one of the Alcohol Prep Pads before applying.
21. I
nput
S
Ignal
w
IrIng
o
VerVIew
The input signal connection is made by tapping into
the signal at the h/k amplifier located on the right-
hand side of the luggage compartment area. From
here the signal runs up the right side of the vehicle to
the dash/console, where the remote volume control
will be mounted, and then back to the ARC subwoofer
amplifier. The connection for the remote turn on lead
for the ARC amplifier is also made at the h/k amp,
and runs directly to the ARC amp.
20. a
ttacH
g
round
w
Ire
Locate the Common Ground point shown. Remove
the nut with a 10mm socket. Strip the end of the
Ground wire, crimp the black 5/16” Gold Ring Ter-
minal to the end. Feed the other end of the Ground
Wire back to the boot area along with the Power
Wire.
19. r
un
p
ower
w
Ire
to
b
oot
Run the Power Wire to the boot, routing it along the
drivers side door sill area, behind the right side rear
interior panel, and to the area behind the small cover
panel removed in Step 7.
Make sure the wire is run clear of any obstructions
or sharp edges, and that it lays flat and does not
obstruct any panels that need to be reattached.
18. a
ttacH
b
attery
l
ead
Remove the auxiliary nut on the battery post and
attach the power wire. Do not install the fuse into the
holder yet.
Secure any loose sections of wire with wire ties. Pull
any remaining slack wire into the cabin.
C. SIGNAL WIRING
23. r
oute
S
Ignal
w
IreS
Connect the RCA-to-Stripped Wire Pigtails to the
“IN” leads on the Remote Level Control and RCA
Interconnects to the “OUT”. Route these wires up
around the console, under and behind the glove box,
along the passenger side door sill, and behind the
right rear interior panel to the h/k amplifier area.
24. I
dentIfy
S
Ignal
w
IreS
Unplug the X10266 connector of the h/k amplfier
(A18). Locate the wires identified in the chart below.
Each set of ++ and -- wires should be a twisted pair.
Confirm the wire by checking the pin number, which
can be observed by removing the gray and black
sections from the housing by lifting/releasing the
retaining notch at the open end of the housing. If
you are not sure you have identified the correct wires
contact us before proceeding!