Integral Audio 1101S, Руководство по установке, Страница: 8 / 12

8 | Integral Audio | Installation Instructions Continued on next page...
25. t
ap
S
Ignal
w
IreS
Unscrew both ends of the Posi-tap. Slip the “U”-
shaped bottom around the signal wire to be tapped.
Carefully thread the body of the Posi-tap onto this
and tighten firmly. Be sure not to cross-thread the
Posi-tap.
31. a
MplIfIer
b
racKet
(o
VerVIew
)
The amplifier bracket mounts against the side of the
left rear wheel well, with the flange on the long side of
the bracket facing down. The large hole in the upper
right (towards the front of the vehicle) slides over the
threaded stud for the common ground point at the
front of the wheel well. The rear hole in the bottom
flange aligns with the hole in the sheet metal below.
Begin by removing the toolkit and nut on the common
ground point.
32. I
nStall tHe
a
MplIfIer
b
racKet
(
part
1)
Insert the Screw Grommet into the hole in the
horizontal section of sheet metal as shown. Place
the bracket with rear horizontal hole aligned with the
screw grommet and the forward hole aligned over the
threaded stud. You may need to bend the bracket
slightly to get it to fit.
30. r
eMote
t
urn
-
on
w
Ire
Strip one end of the 18AWG White Turn-on Lead
wire. Use the remaining Posi-tap connector to attach
the turn-on wire to the Solid White wire at pin 10 of
the connector.
28. H
eatSHrInK
c
onnectIon
29. Slide the heatshrink tubing over the ends of the
Posi-taps. Using a small torch or lighter, gently
and evenly apply heat to the heatshrink tubing until
it shrinks securely over the Posi-tap connections.
There should be no exposed bare wire! Use Cable
Ties to secure the signal wiring as necessary.
27. c
onnect
p
IgtaIlS
(
part
2)
Cut the 4” length of Heatshrink tubing in half and in-
sert one Pigtail (both stripped wires) through one half.
Insert the stripped ends through the top cap of the
Posi-tap and then into the body. Keep the stripped
wire in contact with the body and thread the upper
portion on and tighten firmly.
26. c
onnect
p
IgtaIlS
(
part
1)
Feed the stripped ends of the RCA-to-Stripped Wire
Pigtails to the Posi-taps at the X9331 connector from
the last step. Measure about 8” of excess “working”
wire length and cut the remainder of the Pigtail. Slit
the outer jacket of the Pigtails lengthwise, taking care
not to cut the outer grounding wire. Strip approx 3/8”
of the jacket from the center (positive) conductor.
(You may find it easier to disconnect the Pigtails and
remove them from the vehicle for slitting/stripping).
D. MOUNT AMPLIFIER & CONNECT WIRING
Amplifier Signal Connections
Signal : HK Amp Wire Color: Pin: Connect To:
Rear Left ++ Blue w/ Red Stripe 4 Pigtail 1 White
Rear Left -- Blue w/ BrownStripe 3 Pigtail 1 Ground
Rear Right ++ Blue 2 Pigtail 2 White
Rear Right -- Brown 1 Pigtail 2 Ground
Remote Turn On Solid White 10 18 AWG White