Integra DTR-40.7, Основное руководство

Страница: 8 / 136

Step 1: Connections
En-8
Instructions on how to connect speakers
Cut and remove the plastic coating from the end of the
speaker cable, twist the core and connect it to the terminal�
Be sure to make correct connection between the unit's
jacks and speaker's jacks (+ to + and - to -) for each
channel� If connection is wrong, a bass sound may become
poor due to reverse phase� Up to two subwoofers with built-
in power amplifier can be connected to the SUBWOOFER
jacks� Set the cut-off filter selection switch of the subwoofer
to DIRECT� If the subwoofer does not have a cut-off filter
selection switch but has a cut-off frequency adjusting dial,
turn it to the maximum frequency� If your subwoofer does
not have built-in power amplifier, you can connect a power
amplifier between the unit and the subwoofer�
● The speaker setting is 7�1 channels at the time of
purchase� You can change it manually or by using
automatic speaker setting�
● Short-circuiting the + cable and - cable or contacting
the cable core to the rear panel of the unit may cause
failure� Also do not connect two or more cables to one
speaker terminal or one speaker to several terminals�
When using commercially available banana plugs
:
tighten the speaker terminals to the end and then insert
the banana plugs� Do not insert the core of speaker cable
directly into the hole for banana plug of speaker terminal�
(North American models)