Intec Printing Solutions - Manual for ColorCut LC600 Sheet fed Label Cutter ........................................................................ Page No: 35
5.2 The Blade Holder - an introduction
F
Exposed Blade
E
Flange
D
Lock
C
Blade Depth Adjustment
B
Pin
When handling
cutter blades, be
careful to avoid
cutting your fingers or
other parts of your body.
5.3 Replacing the blade
The blade is a consumable item, and
you’ll always get the best quality cut
with a newer blade. Please replace
with a new blade when the cut quality
reduces.
For Standard blades
(Without the cir-clip)
1. Push the blade into the
bottom of the blade holder.
2. Adjust the amount of
exposed (visible) blade
tip to a suitable length by
rotating
C
the “Adjustment
depth knob” and then tighten
the lock
D
.
3. Press the push-pin
B
to
remove the blade from the blade
holder when replacing blade
Alternative method
(Useful to clear dust with fibrous materials)
1. Unscrew the lower (cover)
part of the blade holder.
2. Insert the blade into the inner
blade holder. Then replace
the outer cover of the blade
holder;
3. Adjust the amount of
exposed (visible) blade tip to
a suitable length by rotating
C
the “Adjustment depth
knob” and then tighten the
lock
D
.
4. Replace the blade by following the
steps above (or you can push the pin
as you do with the standard method of
replacing blades)
C
D
B
D
C
