Intec Printing Solutions - Manual for ColorCut LC600 Sheet fed Label Cutter ........................................................................ Page No: 42
6.2 Checking the Blade depth & Force (Cont.)
The media will be 'REVERSED' back, into the LC600 cutter, until the media lead edge
passes the front paper sensor. The tool carriage will then move towards the right side
of the media.
4.
Press [
CUT TEST
] button on the
LCD display.
L
The LC600 will now cut the shape shown
below.
It will then feed the media FORWARDS
so you can check the cut quality / depth
and pressure.
M
Adjust the [FORCE] using the [+] and [-]
keys on the LCD panel
N
until you can
cut through the top layer of your label
material, and DO NOT cut through the
liner (Base layer).
If you still cut through your media with a pressure <120g then it is likely
you have too much blade exposed. STOP, remove the blade holder and
reduce the blade amount exposed and then test again. IF you can not cut
through normal paper labels or polyester labels with a force >400g, then it
is likely you may not have enough blade exposed.
NOTE: The maximum 760g is for metallic materials and vinyl’s.
5.
Each time you press [
CUT TEST
]
button on the LCD display.
L
The
test cut shape automatically moves so it is
cutting next to the previous test, for you.
O
6.
When you have completed the test of
your cutting pressure and blade depth,
press the [
EJECT
] button
P
on the LCD
display to eject the media. Then press the
[
ON-LINE
]
D
Key to return the cutter
to the HOME screen, and change the LC600
cutter status back, to ONLINE.
⑪
ON LINE
/OFF LINE
ENTER
M
N
ON LINE
/OFF LINE
ENTER
O
P
