MoRoS GPRS 2.1 PRO
Functions
In order to establish an outgoing connection via input 2, it is also neces-
sary, to enter the IP address or the domain name of the target as well as
the port or the IPT dial number. A secondary destination can be entered
optionally. The function itself can be enabled in the menu "In- / Outputs"
on the page "Inputs".
In order to use authentication via TCP or UDP at an INSYS VCom for out-
going connections, select in the "VCom authentication" section for "out-
going" either the radio button "UDP" or "TCP". This authentication will
also be used in leased line mode or when establishing a connection via an
input. This setting is ignored if IPT is used.
Save your settings by clicking "OK". The serial Ethernet gateway will be
restarted with this. Existing serial Ethernet gateway connections will be
terminated.
12.10.2
Configuring the Serial Ethernet Gateway Interface
The serial Ethernet gateway of the MoRoS GPRS 2.1 PRO allows a comprehensive
configuration of the serial interface and the packing of the data arriving there into
TCP packets. It is also possible to use the Telnet protocol. RFC 2217 is also sup-
ported with this, which allows to modify the serial interface parameters during the
operation via a Telnet connection.
Configuration with the web interface
In order to configure the serial interface speed, select in the menu" Serial
Ethernet" on the page "Configuration" the speed in the drop-down list
"Speed (in Bit/s)".
Configure the data format of the serial interface in the drop-down lists
"Data bits / Parity bits / Stop bits".
Select the data flow control (Hardware, i.e. RTS/CTS or Software i.e.
XON/XOFF) in the drop-down list "Flow control". If the connected serial
device does not support the respective data flow control, you must not
use this.
In order to use the control lines DCD and DTR, check the checkbox "Use
modem control lines".
In order to reset the control lines after the connection is terminated, check
the checkbox "Reset modem control lines after connection termination".
In order to specify the maximum block size, from which the serially re-
ceived data are packed to a TCP packet and sent when reached, enter the
value into the field "Maximum block size".
93
Содержание MoRoS GPRS 2.1 PRO
Страница 1: ...Manual MoRoS GPRS 2 1 PRO...
Страница 2: ......
Страница 82: ...Functions MoRoS GPRS 2 1 PRO 82...
Страница 144: ......