CombiLock 200 simplex / pro / pro RFID
Handbuch V.1.10
64
INSYS locks
6
Trouble Shooting / Maintenance
(including Battery Change)
6.1
Optic and Acoustic Signals
Signal
Reason
Comment
2 x
Electronic lock
off
In order to switch on, press
for
2 sec
.
Q
green 1 x
Correct code entry
.
Q
red and 12 x
Incorrect code entry
.
A lockout / blocked time of 10 sec.
follows after the code has been entered
incorrectly 4 times in succession. Each
additional incorrect entry prolongs the
lockout by 10 sec.
Enter
PIN and valid
code two times
after the lockout
ends.
Q
green and 2 x
Modification /
Change OK.
The code change or the activation /
deactivation of a supplementary function
has been carried out properly.
Q
red and 12 x
Invalid attempt at
change.
Code change or switching on or off an
additional function carried out
incorrectly. Repeat process
.
Q
green flashes every
5 sec.
Timed delay
is
running
.
The electronic lock does not respond to
any key entry while the timed delay is
running.
15 x
then
Q
green
Release time is
running (Time delay
has ended).
See section 3.8, Opening with Time
Delay, Alarm Delay and Release Time.
Q
red flashes every 5
sec.
Lockout / blocked
time
is running
.
Lockout / blocked time
cannot be
discontinued / interrupted!
Q
green and 2 x
Lockout
/ blocked
time has ended
.
Signal indicating that the electronic
lock can be opened with the correct
code.
Q
red and green flash
intermittently 10 x and
10 x
Battery charge low
–
Warning.
2 x 1.5 volt MICRO batteries
Type AAA Alkaline (not rechargeable)
should be replaced shortly.
Codes remain the same after
battery change. Enter
PIN and code
twice
after replacing the battery.
Q
green and 1 x
,
then
Q
red and 1 x
Keypad has been
tampered with or
changed
, battery
compartment has
been opened.
In order to open the electronic lock,
enter PIN und code once again.
