insys icom ETSM, Инструкция по установке и эксплуатации

Страница: 31 / 55

ETSM / ETSU Commissioning, Operation and Configuration
ETSM
31
The following settings are available for each port:
Option Value Description
Name
Name of the interface (max. 64 characters, no sem-
icolon or line wrap)
Description
Description of the interface (max. 64 characters, no
semicolon or line wrap)
Link
Enable Port activated
Disable Port deactivated
Speed
100 MBit Port set to 100 MBit
10 MBit Port set to 10 MBit
Auto Port uses auto-negotiation to negotiate the speed
Duplex
Full Port uses full duplex
Half Port uses half duplex
Auto
Port uses auto-negotiation to negotiate the duplex
setting
QoS
Port
All incoming packets arriving at an accordingly
configured port are prioritized.
Tag
Only packets with TOS (type of service) or PCP (pri-
ority code point) field higher than 3 are prioritized.
Table 9 : ETSM – port settings

Ports can be activated or deactivated using "Link Status". Deactivating
unneeded ports is recommended if a link-down event shall be monitored.
Auto-negotiation will negotiate the highest possible speed that is also supported by
the connected destination device. In case that auto-negotiation is not used, the
configuration for speed and duplex must be made for both network participants to
enable communication.

If the speed or duplex mode is set to "auto", this means that both
values are set to "auto".
Changes can be transmitted to the switch by clicking the "Apply" button. The
"undo" button can be used to read back the current configuration.

Deactivating administration ports is not possible due to security reasons.
Therefore, these must be deactivated as administration ports first.
QoS (Quality of Service allows to prioritize network traffic. The switch supports two
different procedures.

Port-based QoS can be activated on maximum 4 ports. Frame-based
QoS has no such limitations.