Page 13 of 22 Rev: 9/30/2011 1:26 PM
[Connection diagram]
Test Operation
1) Turn the power on to the Heating/Air Conditioning system
2) Press the MODE button repeatedly until the HEAT icon appears in the display. Press the UP or
DOWN buttons until the set temperature is 10 degrees above room temperature. The furnace should
turn on.
3) Press the MODE button repeatedly until the COOL icon appears on the display. Press the UP or
DOWN buttons until the set temperature is 10 degrees below room temperature. The air conditioner
should turn on.
NOTE: Most equipment has a time delay of 5 minutes between cool cycles.
4) Press the UP button until the setpoint is equal to the room temperature. Press the FAN button to Fan
On. The fan should turn on and run continuously.
Adding a Wireless Thermostat
The TempLinc can be paired with a wireless thermostat (TempLinc Wireless Zone Thermostat) to provide
a portable thermostat wherever you want temperature control. You can add up to xx wireless thermostats.
1) Press & hold the Set button on TempLinc Wireless Zone Thermostat
TempLinc Wireless Zone Thermostat Set LED goes
GREEN
for xx seconds
2) Press & hold TempLinc Set button
Thermostat will (Beep)
