7. Troubleshooting
Motor overload
Insufficient mixing
Vibrations and noise
Leaks
PROBABLE CAUSES
SOLUTIONS
• •
Viscosity of the liquid too high
Reduce the viscosity, e.g. by heating the
liquid
•
High density
Increase motor power
• •
Tank too big for the chosen mixer
Check with the technical department
•
Wrong direction of rotation
Change direction of rotation
•
Mixer speed too low
Increase the speed
•
Liquid level insufficient or none
Check liquid level in the bank
•
Shaft bended
Replace the shaft
•
Critical speed
Check with the technical department
•
•
Worn or damaged bushing
Replace the bushing
•
Worn or damaged V-ring
Replace the V-ring
•
•
The rotor is rubbing against the stator
Replace the bushing
The attached table lists solutions to problems that may arise while operating the mixer. It is assumed
that the mixer has been properly installed and that it has been selected correctly for the specific
application.
Contact INOXPA if technical assistance is required.
Troubleshooting
13
INOXPA S.A.U.
03.100.30.04EN · (0) 2021/05
