Ø
D
300 400 500 600 800 1000 1200 1600 2000 2500 3000 3500 4000
A
20
30
35
40
50
70
80
115 130 180 200 240 280
S
5
5
10
10
10
15
20
20
30
30
50
50
50
5.4. LOCATION
Place the mixer in such a way as to facilitate inspections and checks. Leave enough room around the
mixer for service, disassembly and maintenance operations. It is very important to be able to access
the electric connection device of the mixer, even when in operation.
To achieve a good mixing process is possible that it be necessary to place baffles in the tank. If this
is the case, consult with INOXPA technical department for each specific application. If necessary, the
approximate dimensions of the baffles according to the tank diameter are be indicated in the next
figure and the next table.
During the transport, disassembly or assembly of the mixer, there is a risk of loss of sta-
bility and that the mixer could fall down and cause damages to the operators. Make sure
that the mixer is properly supported.
ATTENTION
See chapter
to consult the dimensions and weight of the mixer.
03.100.32.0006
If the mixer is not to be installed immediately, it must be stored in an appropriate place. It must be
stored in a horizontal position and placed on wooden supports or for similar material. In this position,
the shaft will not become deformed since it must not be subject to any type of load.
03.100.32.0012
- secure the supports so that they will not move.
Installation
9
INOXPA S.A.U.
03.100.30.04EN · (0) 2021/05
