Innova Xtirpa, Инструкция и руководство по безопасности, Страница: 7 / 40

MU8007-012ENEU rev03 7
recommendations provided by the manufacturer or its certified trainers is not qualified to op -
erate the XTIRPA system and does it at their sole risk, therefore waiving any and all claims,
rights and recourses against the manufacturer and derived therefrom.
n) Make sure to conform to relative demands regarding anchoring devices (E.g.: floor adapt -
er, wall adapter, built-in, etc.) or ensure that the chosen structure that will be used has an
anchoring point, and keep in mind minimal required resistance, equivalency and position.
WARNING: Anchoring devices must be installed only by competent persons or organiza-
tions.
o) The maximum force applied by the system on the structure is, a vertical force of 13 kN, per
EN 362, EN 795: 2012 CE and TS16415: 2013 on the anchor where the system is deposited.
WARNING: The system must be appropriately checked, for example, by calculations or
tests.
WARNING: The use of a base, structural anchor or fastener, if one exists, must be taken
into account when calculating the amount of force supported by the anchor during strength
and integrity testing.
p) A rescue plan shall be put in place in order to account for all likely emergencies that could
occur while working.
WARNING: Any modification or addition to the equipment cannot be done without the prior
written consent of the manufacturer, and any repairs must be undertaken in accordance
with the manufacturer’s procedures.
WARNING: It is agreed and accepted that the use of the equipment (system) is limited to
a maximum of two people.
WARNING: It is important to place the XTIRPA system on a hard and level surface. Do not
use the XTIRPA system on a soft surface, including, but not limited to, sand, grass, gravel
and rocks. If you have any questions about use or maintenance or whether the XTIRPA
system is appropriate for your job, please contact the Manufacturer PSP INNOVA INC.
WARNING: For safety reasons, make sure when using the anti-drop system that you have
enough space under the user, so as to avoid injury. If a fall occurs, there should be enough
space to avoid a collision with the ground or any obstacle. See the diagram in Section 8
for calculating this distance.
IMPORTANT:
It is imperative to respect the mounting compatibilities identified in chapter 5.
***Only the assemblies shown inside this manual are authorized.***