Innova Xtirpa, Инструкция и руководство по безопасности, Страница: 30 / 40

MU8007-012ENEU rev03 30
7.
If a material / positioning winch is required,
use the bottom mounting bracket located
under the davit arm. Install winch to mount-
ing bracket and lock with pin attached to
winch.
(A) . Remove the small pulley locking
pin. Position cable over pulley and re-install
pulley using locking pin.
(B) .
8.
Remove locking pin located in the mid section of the
davit arm.
(A) . Extend the inner mast to full extension
(B) Replace locking pin to secure the davit arm (A) .
IMPORTANT: Make sure that the lifeline cable or rope is directly positioned above the
working area. Only use certified lifeline cables or ropes in perfect condition, that have the
appropriate specifications, including maximum lifting capacity, for the intended use of the
XTIRPA system.
WARNING: It is important to place the XTIRPA system on a hard and level surface. Do not
use the XTIRPA system on a soft surface, including, but not limited to, sand, grass, gravel
and rocks. If you have any questions about the use or maintenance or whether the XTIRPA
system is appropriate for your job, please contact the Manufacturer PSP INNOVA INC.
CAUTION: It is important to never position the XTIRPA system in zones where water can
accumulate and create a hazard.
IMPORTANT: If necessary, secure the work area with a manhole guard to prevent falls.
IMPORTANT: A harness in accordance with EN 361 is the only body support device al-
lowed to be used for fall protection.