Innova Stone Monoblock M1, Руководство по установке, Страница: 40 / 72

40
INSTALLATION
At least one relay used
The Control Panel must have a separate power supply.
1�
Remote Control Panel (mandatory accessory in case of stand-alone M1)
2�
Thermal magnetic circuit breaker and differential protection (not supplied)
3�
Communication cable with Control Panel or H1 indoor unit; shielded two-core cable for RS485 serial connection, minimum cross-section 0.35 mm²,
maximum length 100 m
4�
Power supply Control Panel 12 or 24 VDC - 3 W + the power required by the coils of the relays used
5�
Unit power supply 230/1/50 0 400/3/50 depending on model
1
2
3
4
5
Electrical panel aboard the unit
Connection terminal blocks
1�
Terminal blocks
2�
Rubber gasket
3� Cable gland
1
2
3
To make the connection:
– remove the cable clamp
– insert the cables through the rubber seal
– bring the power cord to the terminal block
– making the connections
– refer to the information in the wiring diagram of the unit
you are installing
After the connection: