Additional Tests
VIEWING DRIVE CYCLE PROCEDURES
94
Red = Excessive over charging or under charging
If the alternator voltage is less than 9 V, the red, yellow and
green SYSTEM STATUS LEDs will flash on and off.
8.
Choose
Main Menu
to return to the Main Menu.
VIEWING DRIVE CYCLE PROCEDURES
A Drive Cycle for a Monitor requires that the vehicle is driven in such a
way that all the required “Enabling Criteria” for the Monitor to run and
complete its diagnostic testing are met. You can use the Scan Tool to
view the Drive Cycle procedures for a selected Monitor.
1.
While linked to a vehicle, press
M
.
The Main Menu displays.
2.
Select
Drive Cycle Procedures
, then press
ENTER
.
A “One moment please…” message displays while the Scan
Tool retrieves Monitor status.
3.
When Monitor status has been retrieved, the Drive Cycle
Procedures menu displays. Depending on Monitor status, you can
view Drive Cycle procedures for
Monitors Incomplete
or
Monitors
Complete
.
If Drive Cycle Procedures are not
available for the vehicle, an
advisory message shows. Choose
Back
to return to the Main Menu.
4.
Select
Monitors Incomplete
or
Monitors Complete
, as desired, then
press
ENTER
.
A list of the available Monitors for
the selected status displays.
If no Monitors for the selected
status are detected, an advisory
message shows. Choose
Back
to
return to the Main Menu.
5.
Select the Monitor for which you wish to
view Drive Cycle Procedures, then
press
ENTER
.
A “One moment please…” message displays while the Scan
Tool retrieves the requested Drive Cycle Procedure. The Drive
Cycle Procedures screen for the Monitor displays when the
procedure has been retrieved.
If a Drive Cycle Procedure for the selected Monitor is not
available, an advisory message shows. Choose
Back
to return
to the Main Menu.