8520-R1 4-Port Wireless N Gateway
51
User Name:
Manually enter your PPPoE User Name which will be provided by your ADSL
service provider or ISP.
Password:
Manually enter your PPPoE Password which will be provided by your ADSL
service provider or ISP.
Type:
Select your connection type from the drop down manual. This 4-port Wireless N
Gateway provides 3 connection type:
Continues (Default Setting)
Connect on Demand
Manual
WAN IP:
Default Route:
Click the radio button to
“Enable”
or
“Disable”
the default Route
functionality. Default setting is
Enable
.
Configuration Procedure :
1. From the
WAN
– Channel Config
page, click and select
PPPoE
connection mode from the Channel
Mode drop down manual. The default
PPPoE
connection setup is displayed.
2.
Select the Channel Mode to “PPPoE”. Set the parameters VPI/VCI and Encapsulation mode according to
the ISP setting.
3. Click the radio button and select the Encapsulation type ( LLC or VC-Mux).
Note:
Your ADSL service provider or your ISP will supply these. In this case the ADSL service
provider is using LLC.
4. Check the radio button to
“Enable”
or
“Disable”
the NAPT setting. Leave as it
’s default setting if your
ADSL provider or ISP didn
’t provide any setting information.
Note: NAPT:
Network Address and Port Translation: An extension of NAT, NAPT maps many
private internal addresses into one IP address. The outside network (WAN) can see this one
IP address but it cannot see the individual device IP addresses translated by the NAPT.
5. Enter your
Username
and
Password
which will be provided by your ADSL provider or ISP.
6. Select the Connection Type form the drop down manual or leave as it
’s default setting (Continuous).
7. Click the radio button to
“Enable”
or
“Disable”
the Default Route functionality or leave as its default
(Enable).
8. Click
“Add”
button after setup.
9. You can
“Edit”
(
) or
“Delete”
(
) the existing connection profile under the
Actions
column.
10. Click
“Admin/ Commit/Reboot”. Press “Commit” to save the settings into flash memory.
11. The new settings will take effect after reboot the system.
12. The following window display indicates the system restarting process.