Inner Range Inception Security Controller
Installation Manual. Rev. 4.0
© 2016 - 2020. Inner Range Pty Ltd.
23
www.innerrange.com
Power supply outputs.
NOTES:
1. The Inception Controller PCB Revision can be viewed via one of the following methods.
-
LCD Terminal: Logon as Installer. Press; MENU, 5, 1, then use the ‘V’ key to scroll to the screen
sho
wing ‘PCB Revision ^v’. The PCB revision will be shown on the bottom line of the display.
-
Browser: Logon as Installer. Select; System > Firmware Update > Update Controller. Under the
heading ‘Inception System Information’, see ‘Inception Revision: Rev ?’ for the PCB revision.
See
“Firmware Update” in the ‘Maintenance’ section of this manual for an example.
2.
See the “Parts & Accessories” Lists in this manual for details of power supply current requirements of the
accessories and expansion modules that may be powered from the Inception controller power supply.
3. A separate external battery-backed power supply may be required for devices connected to the Inception
controller if the current required is in excess of the maximum current allowed for that power supply
output, or causes the maximum combined output current specification to be exceeded.
OUTPUT
VOLTAGE
MAXIMUM CURRENT
See Note 1 above.
PCB REV. A or B
PCB REV. D or later
USB:
5 V DC
500 milliAmps
LAN +:
13.4 V DC. +/-150mV
350 milliAmps
V OUT:
2-
pin connector near ‘BATT’
13.4 V DC. +/-150mV
1.5 Amps
V OUT:
4-pin connector near Inputs.
13.4 V DC. +/-150Mv
750 milliAmps
1.5 Amps
:
13.4 V DC. +/-150mV
1 Amp
1.1 Amps
Maximum combined peak
current from these 5 outputs:
2.5 Amps
3 Amps
