64
Argus Devices
Installation and programming manual
Appendix B
Argus Devices
Note:
The ARGUS devices accepted by this control panel do not have IMQ-SECURITY SYSTEMS certification;
refer to the instructions leaflet provided with each device.
All Argus Vega devices have built-in loop isolators. Therefore, isolators are not required. A short-circuit on
the loop will not provoke loss of any device.
Each detector is equipped with a 3-colour LED: green (periodic blinking) indicates the detector is working
properly (if enabled). Yellow indicates fault or open isolator status; red indicates alarm status (if enabled by
the operator).
Detectors are equipped with test LEDs: if you hold a magnet near the detector base (near to the two
notches) the detector should generate an alarm signal.
B.1
Devices
Model
Name
Description
V100
Analogue optical smoke detector
Optical smoke detector
V200
Analogue multicriteria detector
Optical smoke and heat detector
V350
Analogue heat detector
Heat detector (
a
)
VCP100
Intelligent resettable callpoint
Resettable callpoint
VWCP100
Weatherproof intelligent resettable callpoint
Resettable callpoint for outdoor installation
VMI100
Input module
Module with 1 supervised input
VMMI100
Input minimodule
Minimodule with 1 supervised input
VMDI100
DIN rail input module
DIN rail module with 1 supervised input
VUMI100
Input micromodule
Micromodule with 1 supervised input
VMC100
Output module
Module with 1 supervised output
VMMC100
Output minimodule
Minimodule with 1 supervised output
VMDC100
DIN rail output module
DIN rail module with 1 supervised output
VUMC100
Output micromodule
Micromodule with 1 supervised output
VMC120
Output module Form C
Module with 1 voltage free relay (non-supervised)
VMMC120
Output minimodule Form C
Minmodule with 1 voltage free relay (non-supervised)
VMDC120
DIN rail output module Form C
DIN rail module with 1 voltage free relay (non-supervised)
VUMC140
Output micromodule Form C
Micromodule with 1 voltage free relay (non-supervised)
VMIC100
Input/Output module
Module with 1 supervised input + 1 supervised output
VMMIC100
Input/Output minimodule
Minimodule with 1 supervised input + 1 supervised output
VMDIC100
DIN rail input/output module
DIN rail module with 1 supervised input + 1 supervised output
VMIC120
Input/Output module Form C
Module with 1 supervised input + 1 non-supervised output (voltage
free contact)
VMMIC120
Input/Output minimodule Form C
Minimodule with 1 supervised input + 1 non-supervised output
(voltage free contact)
VMDIC120
DIN rail input/output module Form C
DIN rail module with 1 supervised input + 1 non-supervised output
(voltage free contact)
