26
Installation instructions
Installation and programming manual
Chapter 6
Installation instructions
6.1
Installing the extinguishant module (accessory item)
The extinguishant module is packed in a separate cardboard box. Together with the extinguishant module
(IN015), you will find a plastic bag containing:
• Pin header for the extinguishant module to SmartLight motherboard connection
• Screws
• EOL resistors and diodes
Figure 10 - Mounting the extinguishant module
1. Remove the four securing screws and the frontplate.
2. Remove the four securing screws and the plastic support.
3. Position the SmartLight motherboard as shown in the figure.
4. Locate the extinguishant module in its housing.
5. Using the four screws, secure the extinguishant module in position.
6. Connect pins J17 of the SmartLight motherboard (paragraph 4.1 -
[R]
) to the respective pins J2 on the
extinguishant module.
7. Move the SmartLight motherboard back to its original position.
8. Replace the plastic support.
6.2
Wall mounting
6.2.1
Control panel
1. Pull the wires through the wire entry and ensure they do not get in way of operations.
2. Using the wall plugs, attach the backplate to the wall.
Danger:
Care must be taken not to drill in the vicinity of electrical wiring, heating ducts and plumbing.
6.2.2
Repeater (optional system enhancement panel)
1. Remove the four frontplate screws and lift off the frontplate.
2. Pull the wires through the wire entry on the back of the repeater and ensure they do not get in way of
operations.
3. Using the wall plugs, attach the backplate to the wall.
1
2
3
4
5
6
