12
The SmartLiving System
User’s Manual
2-3-3
Using the keypad
The following section describes how the keys are normally used. Some of the
keys may have specific functions which will be indicated when necessary.
2-3-4
Emergency keys
This control panel provides 3 "key-duos" for Emergency Calls which can be
activated by pressing the respective keys on any of the system keypads:
1.
+
= Fire Emergency
2.
+
= Ambulance Emergency
3.
+
= Police Emergency
Utilization of any of the "key-duos" will generate the respective events and
actions (e.g. activation of outputs and calls).
To activate an emergency call, press simultaneously and hold keys
+
,
or
+
, or
+
for at least 3 seconds until the selected
emergency call is confirmed by a beep.
Note
If any two function keys are pressed at the same time, the functions relating to the icons
associated with the keys will not be activated.
2-3-5
Visual signals on the keypad LEDs
The following table describes the visual signals on the keypad LEDs.
Table 4:
The keys
Keys
Name
Typical application
Number keys
Used to type in User PINs
OK
Confirms the selected item (parameter, etc.)
UP, DOWN
Navigate through the menu lists or adjust keypad volume
LEFT, RIGHT
Scroll along the data rows (for example, partitions in the events log, etc.).
C
Steps back on the open menu without changing the selected item (parameter, etc.) or,
after entering a User PIN and pressing
, runs through the 3 User-menu templates
(refer to paragraph
2-5 User Codes
) each time it is pressed.
ESC
Exits the User menu without changing the selected item (parameter, etc.).
ENABLE
Enables options (refer to paragraph
5-4 Activations
)
DISABLE
Disables options
F1, F2, F3, F4
or function keys
Activate the shortcuts which correspond to the associated icons.
Can be used also as Emergency keys (refer to paragraph
2-3-4 Emergency keys
).
Panel T03
DASIDASI--
Press simultaneously
Table 5:
Keypad LEDs
LED
Red
Yellow
Blue
Green
OFF
(no light)
All the keypad partitions are
disarmed.
No faults present.
Open zones on the keypad
partitions.
Primary power failure (230V
a.c.)
ON
(Solid)
At least one of the keypad
partitions is armed.
At least one fault has been
detected.
All the zones on the keypad
partitions are in standby
status: Ready to arm.
Primary power OK (230V a.c.)
Slow blinking
(ON: 0.5sec
OFF: 0.5sec)
All the keypad partitions are
disarmed. Memory of alarm/
tamper on at least one of the
keypad partitions or memory
of a system alarm.
No faults present. At least one
of the zones belonging to the
keypad partitions is either
disabled (inhibited) or is in
Test status
All the zones belonging to the
keypad partitions are in
standby status. (For JOY/MAX
only: an unplayed voice
message is present in the
memo box).
Fast blinking
(ON: 0.15sec
OFF: 0.15sec)
At least one keypad-partition
is armed. Memory of alarm/
tamper on at least one of the
keypad partitions or memory
of a system alarm.
At least one fault is active and
at least one zone belonging to
the keypad partitions is either
disabled (inhibited) or is in
Test status.
Open zones on the keypad
partitions. (For JOY/MAX only:
an unplayed voice message is
present in the memo box).
Содержание SmartLiving 10100L
Страница 45: ...User s Manual 45 Notes...
Страница 46: ...46 User s Manual...
Страница 47: ...User s Manual 47...