InHand InGateway501, Руководство пользователя

Страница: 51 / 204

InGateway Documentation, Release 0.0.1
* 100M Full Duplex
* 100M Half Duplex
* 10M Full Duplex
* 10M Half Duplex
– Track L2 State: enables or disables tracking of L2 interface status. After this feature is enabled,
the interface is Down when it is not physically connected and is Up when it is physically connected.
After this feature is disabled, the interface state is displayed as UP regardless of whether the
interface is physically connected.
– Shutdown: disables the interface.
– Description: specifies the descriptive information that identifies the Ethernet interface.
– Secondary IP Setting: allows you to set up to 10 secondary IP addresses in addition to the
primary IP address.
• DHCP mode
– Description: specifies the descriptive information that identifies the Ethernet interface.
3.3.1.3 WLAN
The WLAN page displays the WLAN configuration and status on the IG902. You can set WLAN parameters
or view detailed WLAN status information on this page. Follow these steps to configure WLAN parameters:
1. Choose Network > Network Interfaces > WLAN to display the WLAN page.
2. Select Enable Wi-Fi , and then select options or enter values for the parameters. For details about
these parameters, see WLAN parameter description.
3. Click Submit to complete the WLAN configuration.
The following figure shows the configuration of the gateway as a wireless access point (AP).
1.2. InGateway902 User Manual 47