InHand InGateway501, Руководство пользователя

Страница: 167 / 204

InGateway Documentation, Release 0.0.1
• Static IP mode
– Primary IP: specifies the IP address of the Ethernet interface. By default, the IP address of FE
0/1 is 192.168.1.1.
– Netmask: specifies the subnet mask of the Ethernet interface.
– MTU: specifies the maximum transmit unit, which is expressed in bytes. The default value is
1500.
– Speed/Duplex, including:
* Auto Negotiation
* 100M Full Duplex
* 100M Half Duplex
* 10M Full Duplex
* 10M Half Duplex
– Track L2 State: enables or disables tracking of L2 interface status. After this feature is enabled,
the interface is Down when it is not physically connected and is Up when it is physically connected.
After this feature is disabled, the interface state is displayed as UP regardless of whether the
interface is physically connected.
– Shutdown: disables the interface.
– Description: specifies the descriptive information that identifies the Ethernet interface.
– Secondary IP Setting: allows you to set up to 10 secondary IP addresses in addition to the
primary IP address.
• DHCP mode
– Description: specifies the descriptive information that identifies the Ethernet interface.
3.3.1.3 Loopback
The loopback interface is a logical, virtual interface on the IG501. After you create and configure the loopback
interface, you can ping its IP address or set up a Telnet connection to it to test the network connectivity.
You can set or view loopback interface parameters on the Loopback page. Follow these steps to configure
the loopback interface:
1. Choose Network > Network Interfaces > Loopback to display the Loopback page. You can
set or view loopback interface parameters on this page.
2. Click the Add icon in the table under Secondary IP Setting to add a secondary IP address for the
loopback interface. (The default IP address is 127.0.0.1.)
3. Enter the secondary IP address and subnet mask.
1.5. InGateway501 User Manual 163