Terminal User Guide
Page 6
iWL250 User Guide
Copyright© 2019 Ingenico
Terminal Management System
Approximately once a month your terminal will call the Terminal Management
System (TMS) to receive any updates to the software, details of new card
schemes, and any changes to your configuration. This call will take place
automatically, normally outside of standard trading hours and therefore it is
important that your terminal is powered on. For Bluetooth or Wi-Fi terminals, it
should remain connected to a telephone line or Local Area Network (LAN); for
mobile terminals, it should remain in an area of good mobile network signal.
Supervisor Password
Your terminal’s Supervisor functions can be accessed by means of a Supervisor
password, and therefore you are not supplied with a Supervisor Card.
Your terminal is shipped with an initial default password of
01483
, but is
configured so that a change of this password is required before you process any
transactions.
If you wish to do this before performing a transaction you should refer to the
section entitled
Supervisor Password
for information on how to change the
Supervisor password.
You are strongly advised to ensure that privileged access to your terminal
(including access to the Supervisor password) is only granted to staff that have
been independently verified as being trustworthy.
End of Day Process
Your terminal is an ‘online’ terminal, which means that transactions are captured
when you take them so there is no requirement for ‘polling’ the terminal. You
must however ensure that you perform your End of Day reports, to find out more
refer to the section entitled
Reports
.
Paper Rolls
You should only use approved paper rolls as supplied by your terminal supplier.
Details on how to contact us to order supplies of paper rolls can be found on the
contact sticker on the underside of your terminal. If appropriate, you may also
find these details on the inside cover of this User Guide.
