INGENIA 2147502492, Руководство по эксплуатации продукта

Страница: 22 / 90

Everest XCR - Product manual | Connectors Guide
INGENIA | 2020-10-01 00:04:38 22
Warning, power supply and motor terminals can have dangerous voltages in excess to 50 V and cause electric
shock. Never touch them directly while in operation. The end installation must ensure that these terminals are
not accessible.
Recommended section wire is 2.5 mm
2
~ 5.3 mm
2
, AWG 10 ~ AWG 13. Adapt the cable diameter to the worst-case
current needs.
It is recommended to use flexible silicone or Teflon cables with high-temperature ratings ≥ 180 ºC. The diameter
of the cable jacket (insulator) should be less than 5.08 mm to prevent collision between wires.
The cables must always be mechanically secured after soldering.
When using power supply only (no logic supply) it is recommended to connect pins 27 (+LOG_SUP) and 29
(GND_D) of I/O connector J2 together.
7.3. Motor
P2 connector
2.6 mm diameter gold plated solder pads or flying leads option. Pad pitch is 5.08 mm.
Pin Signal Function Warning! Risk of electric shock!
1 PH_A Motor phase A
2 PH_B Motor phase B
3 PH_C Motor phase C
4 PE Protective earth connection, internally connected to standoffs and drive housing.
Notes
Warning, power supply and motor terminals can have dangerous voltages in excess to 50 V and cause electric
shock. Never touch them directly while in operation. The end installation must ensure that these terminals are
not accessible.
Recommended section wire is 2.5 mm
2
~ 5.3 mm
2
, AWG 10 ~ AWG 13. High-temperature materials are necessary
( ≥ 180 ºC).
The cables must be mechanically secured after soldering.
For long cables, it is essential to use a shielding connected to protective earth at both ends of the cable.
More information
Check the Power Supply and Motor Power section for further information on how to connect the Everest
XCR to a power supply and motor.
