Infortrend EonStor S12F-G1433, Руководство по установке и аппаратным средствам

Страница: 55 / 124

Chapter 2: Hardware Installation
hammer, step on it, or throw it. These actions could damage
or deform it and internal short-circuiting can occur, possibly
causing functional defects, acid leaks, and other hazardous
results.
․
use the BBU, return it to Infortrend
or your system vendor.
2.9.2 Installation
To install a BBU, please follow these steps:
Step 1.
medium size
Phillips screwdriver. (See the figure below)
If a BBU leaks, gives off a bad odor, generates heat,
becomes discolored or deformed, or in any way appears
abnormal during use, recharging or storage, immediately
remove it from the subsystem and stop using it. If this is
discovered when you first
Procedure
Remove the BBU bay metal cover from the chassis by
loosening the retention screws using a
Step 2.
the BBU until it is fully inserted. (See the
figure below)
Figure 2-25: Removing the BBU Bay Metal Cover
Install a BBU by aligning it with the module bay and then
gently pushing
Figure 2-26: Installing the BBU
Step 3. the
retention screws on the BBU. (See the figure above)
Step 4.
fully charged, the LED
will turn off. (See the figure below)
Secure the BBU to the subsystem by fastening
The LED should start flashing to indicate that the BBU is
being charged. When the BBU is
2-21