Infinova V3062 Series, Инструкция по установке и эксплуатации

Страница: 28 / 40

20
Enter the "Manual recording" interface via the main menu "Record"
or
Ǐ
REC
ǐ
key on the front panel, as shown in Figure 4-12.
Figure 4-12
(1) Status list
The status shows the recording status of all 16 channels.
The different icon of each channel indicates the status, as follows
Table 2 Icon introduction for recording status indicators
Indicator
Icon
Color Status
Gray No video
Yellow Normal
Reserved Manual recording
Green Scheduled recording
Red Alarm recording
(2) Start/Stop manual recording
1. Start/Stop manual recording in single channel
Select the channel number (the small check box under the
indicators), and press
Ǐ
ENT
ǐ
key to start/stop the manual
recording.
2. Start/Stop manual recording in all channels
Move the cursor to "Select All" button, and press
Ǐ
ENT
ǐ
key to
select all channels and start the manual recording. Press
Ǐ
ENT
ǐ
key
to cancel the selection to stop the manual recording.
Note :
(1) For manual recording, it must stop manually, or the DVR will
keep on recording. Since the priority of alarm recording is higher,
the manual recording will stop when the channel is in the alarm
recording status. The manual recording resumes after finishing the
alarm recording.
(2) It's not necessary to restart the manual recording if reboot the
DVR.
4.7.2 Scheduled Recording
Enter the "Recording management" interface via the main menu
"Record" or
Ǐ
REC
ǐ
key on the front panel, and press
Ǐ
WIDE
ǐ
key to switch to "Recording Settings" option, as shown in Figure
4-13.
Figure 4-13
1. Select recording channel
Move the cursor to "Channel", press Ǐ ENT ǐ key to open the
drop-down list and select the desired channel, and press Ǐ ENT ǐ
key.
2. Set pre-recording and post-recording
Move the cursor to set the pre-recording (default: 4 seconds) and
post-recording time (default: 5 seconds). The DVR will record the
video of 4 seconds before start recording and 5 seconds after stop
recording.
Note
: This function is valid for alarm recording only.
3. Set recording schedule
Move the cursor to "Recording schedule", and press Ǐ ENT ǐ key to
enter setting interface. Select recording date and time sector, and set
the "Recording Type" to "Time Recording", as shown in Figure
4-14. Refer to "Set schedule" of "video mask alarm" in section 4.5.1
for the recording schedule settings.
Figure 4-14