17
Figure 4-6
Below section has detailed introduction on the setting and method
for the three different types of alarm.
1. Video mask alarm
As shown in Figure 4-6, press
Ǐ
ENT
ǐ
key to call out the
drop-down list to select the desired channel, and press
Ǐ
ENT
ǐ
key
to confirm the selection. Select the video mask option, and press
Ǐ
ENT
ǐ
key to enable it, and allow mask alarm setting (sensitivity,
area, schedule time, linkage). The "mask alarm" option will
disenabled when press the
Ǐ
ENT
ǐ
key if it's selected.
(1) Set sensitivity
The default sensitivity level is “medium”. Press
Ǐ
ENT
ǐ
key to call
out list after move the cursor to the "Sensitivity" option, and select
the desired sensitivity level, and then press
Ǐ
ENT
ǐ
key. Three
levels are available, high, medium and low.
(2) Set area
Press
Ǐ
ENT
ǐ
key to enter area setting menu after selecting "Area"
option. Press
Ǐ
IRIS+
ǐ
key to enable the cursor. Move the area
frame via
Ǐ
ǐ
,
Ǐ
ǐ
,
Ǐ
ǐ
and
Ǐ
ǐ
keys. Press
Ǐ
ENT
ǐ
key
to enter the editing status of the frame size, and set the size of the
frame via
Ǐ
ǐ
,
Ǐ
ǐ
,
Ǐ
ǐ
and
Ǐ
ǐ
keys, and press
Ǐ
ENT
ǐ
key to confirm. After press
Ǐ
ENT
ǐ
key , the next frame will pop
up automatically, press
Ǐ
ESC
ǐ
key to exit and save the setting.
Note:
In the area setting status, press
Ǐ
*
ǐ
key to select all the areas,
and
Ǐ⬄ǐ
key to clear all the areas. In this system, the full screen
area is regarded as the mask alarm area regardless its size.
(3) Set schedule
Move the cursor to "Schedule" option and press
Ǐ
ENT
ǐ
key to enter
"Schedule Settings" interface, as shown in Figure 4-7.
Figure 4-7
In the interface, move the cursor (the white bar) to the desired
schedule time, and press
Ǐ
ENT
ǐ
key, then the area selected will
turn to green. Press
Ǐ
ESC
ǐ
key to exit.(The focus will go to "Select
All" button.)
Press "Confirm" to save the schedule time setting. Press "Exit" to
return to "Channel" interface.
(4) Set alarm output
Move the cursor to the "Output" option of video mask alarm, and
press
Ǐ
ENT
ǐ
key to enter alarm output setting interface, as shown
in Figure 4-8.
Figure 4-8
The DVR support 4 output modes.
y
Audible warning
: The built-in beeper generates sound when
there's mask alarm.
y
Control center
: The system transmits the alarm message to
client end when there's mask alarm to remotely handle the
alarm by client end.
Note
: For this output linkage, it's necessary to set the address of
alarm center as the IP address of the PC that runs the client end via
the "Network Settings" in the submenu.
y
Alarm preview:
Generate alarm preview when there's mask
alarm.
Note:
The alarm preview could realize self-adaptive
