Inficon Transpector SPS, Руководство по эксплуатации

Страница: 133 / 174

8 – 3
Transpector SPS Operating Manual
Process valve(s) do not
open Low air pressure Check air pressure
Leaks in air lines Listen/check for leaks
Water vapor high in
background mass
spectrum Exposure to air or water in
process Bake out manifold and Inlet
to 150 °C for 8 hours.
Check for water after cool
down
Power indicator on
controller does not
illuminate +24 V controller internal
power supply Check input AC line voltage
to external power supply
Check +24 V input, verify
input range 20–30 V
Replace power supply
Controller electronics
failure Return controller to
INFICON for repair
Power indicator on
Transpector cable box
does not illuminate Controller is not on Refer to section 2.2.1,
Attach Transpector
Electronics Module, on
page 2-1
Transpector SPS control
cable is disconnected Check control cable at
controller end and at cable
box end
No communication to
HOST computer Sensor IP address not
compatible with network Refer to Chapter 3,
Connecting
Transpector SPS
Transpector
communications port (port
80) is not open on the host
computer Open port 80 on the host
computer or change the
communications port of
Transpector SPS
Cable connections Make sure cables are
connected to proper
connectors
Host computer Ethernet
malfunction Replace Ethernet Card on
host computer
Table 8-1 Symptom—Cause—Remedy Chart (continued)
SYMPTOM CAUSE REMEDY