iNetVu™ 5000 Controller User Manual
Page 22 of 77
3. Advance to the iNetVu Maintenance Screen, click in the “Enable RF Search”
Check box, and then click the “Send RF” Button.
4. When you are prompted to write to the EPROM, click “
OK
” to confirm the
operation. This is a crucial step in successfully applying the switch.
5. Reset the controller using the “reset” button on the front panel, or through the
“Reset Controller” button in the maintenance menu. Wait until the controller
is fully reset and all parameters are successfully read before proceeding to
the next step.
6. Power off the iNetVu
TM
5000 Controller, and switch the Rx controller cable
from the DVB Tuner “Rx IN” input to the “Rx Aux” input.
7. Power on your 5000 Controller, and you will be set to function in RF mode.
Note: To switch back to DVB mode, uncheck the “Enable RF search” check box,
click the “Send RF” button, save to EPROM when prompted, and reset the
iNetVu
TM
5000 Controller. Ensure that your controller is powered off before
switching the Rx Cable from the RF input back to the DVB input.
