Indian Motorcycle Chief 2010, Руководство пользователя

Страница: 37 / 90

decrease noise. Th e primary chain should be checked
and the oil changed after the fi rst 500 miles and every
5000 miles thereafter.
Th e primary chain is located inside the primary housing
on the left side of the motorcycle (See fi gure 25) . If the
chain is loose worn or damaged in any way, it will cause
the motorcycle to run improperly and the chain and
sprockets to wear excessively.
Primary Chain tension adjustment
1. Remove the inspection cover.
2. Place a small ruler inside the case and against the
primary chain. Grasp the top run of the primary
chain and defl ect upward.
3. Measure the defl ected chain slack. Th e correct chain
slack is 9/16˝-5/8˝. Adjust the chain if not within the
specifi ed range.
4. To adjust the chain, loosen the adjuster nut.
Move the nylon slipper up or down to achieve the
correct tension.
5. Tighten the adjusted nut and torque to 22-28 foot
pounds.
6. Clean the threads of the inspection cover screws.
Place blue thread locking compound on the threads.
Tighten the screws to 95-115 inch pounds
Primary Oil Change
To change the primary oil warm the bike to operating
temperature by riding it for 10-15 minutes. Th
e primary
oil drain plug is located under and to the rear of the
inner primary cover
1. Place a catch basin with a volume of at least 30
ounces below the drain plug.
2. Remove the magnetic plug and let the oil drain from
the bike.
3. Remove any debris from the magnetic drain plug.
Add anti-seize to magnetic drain plug.
4. Replace the drain plug and torque to 11-13 foot
pounds.
5. Remove the small round inspection cover.
6. Pour 20-22 ounces/ 591-650cc of Indian® brand
primary oil through the inspection hole.
7. Reinstall the round inspection cover.
Maintenance and Lubrication
37
Figure 25: Primary chain and housing