17
Visit www.improvedracing.com for additional support
3.
Reinstall the modified black plastic shroud onto the vehicle by finagling
the hoses into the cutout, followed by reinserting the plastic push-clips.
4. With two people, carefully place the bumper straight onto the front of
the car.
Tip:
Be sure to connect all wire harnesses and lock the safety tab!
5. Peel-back the wheel-well linings on each side to:
a. Connect all fog light harnesses.
b. Use an extended 10 mm tool to replace the four screws securing the
bumper cover to the fender support
c. Use a 7 mm tool to replace one screw securing the bumper cover to
the fender.
6. Use a 7 mm tool to replace all screws in the wheel wells. Cite Figure 4 for
locations.
7. Put the wheels back on, if applicable.
8. Use a T20 tool to replace all screws underneath the bumper cover, im-
mediately in front of the wheels. There are four per side. Cite Figure 5
for locations.
9. Use a 10 mm tool to replace the two screws on the bottom which hold
the bumper cover to the chassis. Cite Figure 2 for locations.
10. Use a 10 mm tool to replace the screws at each corner under the hood.
Cite Figure 1 for locations.
11. Replace all of the plastic pop-clips underneath the hood which pin the
bumper cover to the radiator support. Cite Figure 1 for locations.
12. Peel-off all masking tape from the fenders.
13. Close the hood and safely lower vehicle back onto the ground.
14. Take a test drive to ensure performance is as desired.
15.
Check for loosened fittings and leaks after 50 miles of driving.
Installation is now complete. Thank you for purchasing an Improved Racing
product!
