16
Visit www.improvedracing.com for additional support
PREPARING FOR STARTING
1. Check the engine oil level and add oil if necessary.
2. Remove the fuel injector fuses.
Tip:
Consult the vehicle’s factory service manual for the fuse locations.
3.
Crank the engine over for five seconds to build oil pressure, repeating
this cycle three to five times.
4. Replace the fuel injector fuses removed previously.
5. Check the engine coolant level and add coolant if necessary.
Tip:
Consult the vehicle’s factory service manual for the correct inspec-
tion and filling procedures
6. Start the vehicle and inspect for oil and coolant leaks.
Be sure the engine does not begin to overheat.
7. Turn-off the vehicle, inspect the engine oil and coolant level and add oil
or coolant when necessary.
REINSTALLING THE BUMPER COVER
1. Use a 10 mm tool to replace the four screws securing the black beak to
the front of the car, shown in Figure 5.
2. Cut the black plastic, lower radiator shroud as shown in Figure 19.
5” MIN
Figure 19 - Trimmed Black Plastic Lower Radiator Shroud
