5
Visit www.improvedracing.com for additional support
4. Use a plastic prying tool to remove all of the plastic pop-clips underneath
the hood which pin the bumper cover to the radiator support, circled in
green
on Figure 1.
5. Use a 10 mm tool to remove the screws at each corner under the hood,
circled in
red
on Figure 1.
6. Underneath the car, use a 10 mm tool to remove the two screws which
hold the bumper cover to the chassis, circled in
green
on Figure 2.
7. Use a T20 tool to remove all screws underneath the bumper cover, im-
mediately in front of the wheels, circled in
green
on Figure 3. There are
four per side.
Figure 2 - Removing the Bottom Bumper Cover Screws
Figure 3 - Removing the T20 Torx Screws
