14
Visit www.improvedracing.com for additional support
16. Use Figure 16 to locate the power steering line that is secured to the
chassis by a cushioned clamp and use a 10 mm tool to loosen the screw
holding the clamp.
17. Expand HCP-1016 and insert the oil lines through the cushioned clamp.
18. Remove the screw from the steering line clamp on the chassis and slide
HCP-1016 over/underneath the steering line clamp, depending on what
best suits the line configuration and power steering line.
19. Reinsert the screw into the chassis and tighten to no more than 7 lb-ft
(10 N-m).
20. Peel-back the black plastic shroud circled in
green
on Figure 17 and route
the system lines up towards MHX-245.
21. Use two HTD-1004 from the E5G-600-64 Hardware Kit to secure the
hoses onto the M8 screw that was installed into the washer fluid tank
previously, as shown in Figure 18.
22.
Apply some oil to the lower fitting’s flare on MHX-245 and connect the
45° hose-end. Tighten the hose-end to 20 lb-ft (27 N-m).
23.
Pre-fill the heat exchanger with engine oil using a tube and funnel.
Tip:
Use a flexible tube with a MAX O.D. of 0.50” (12.7 mm).
Figure 16 - Chassis Location for Factory Power Steering Clamp
