Immergas VICTRIX Zeus 26 1 I, Руководство пользователя

Страница: 23 / 46

21
STVZ1I ed 10/09 VICTRIX Zeus 1 I
Technical Documentation Technical Documentation
Intake and exhaust systems
(see intake and exhaust terminals instructions)
The VICTRIX Zeus 1I boiler is prepared for connection to the
appropriate snap-fit intake/exhaust pipes and can be installed
inside the home or outside the home or outside of the home (in
a partially protected place) in the following configurations:
Outdoor (in partially protected place):
- with sealed chamber and fan-assisted circulation with direct
intake (type C) using an appropriate top cover kit (optional)
mandatory;
- with sealed chamber and fan-assisted circulation (type C)
using the vertical or horizontal concentric kits, keeping the
lateral plugs without the obligation to use the top cover
kit.
Indoor:
- open chamber and fan-assisted circulation (type B23) using
an appropriate top cover kit (optional) mandatory;
- with sealed chamber and fan-assisted circulation (type C)
using the vertical or horizontal concentric kits or the Ø 80/80
separator kit.
For that regarding the head losses relative to each accessory,
for the various combinations that can be performed, see the
instructions relative to the intake and exhaust terminals
(boiler instruction book).
The generators with condensation technology must be installed
using the specific series of intake and exhaust pipes, which have
been designed to be coupled exclusively to the Immergas
condensing boiler.
The “GREEN SERIES” flue kit is made in plastic (PPS = self-
extinguishing polypropylene) suitable for resisting the corrosive
action of the acid condensate.
Configuration with sealed chamber and fan-as-
sisted circulation with direct intake (type C) for
installation outdoors in a partially protected
place (see figure at the side).
Using a relevant cover (1) to position on the upper part of the
sealed chamber, it is possible to install the boiler outdoors in
partially protected places.
Intake.
Assembly of the lid (1) envisions the removal of the cap placed
to close the hole in the upper part of the sealed chamber and
the use of a relevant diaphragm (3) to cover the intake hole.
Combustion air intake takes place directly from the environ-
ment, making use of the free space between the lower part of
the cover (1) and the upper part of the boiler.
Exhaust.
The 80 mm diameter exhaust pipe fitting is obtained using the
flange (2) used in the divided systems.
The use of relevant accessories allows horizontal (A) or vertical
(B) exhaust.
To prevent condensate problems, the exhaust pipe must be
limited to 30 straight metres.
Configuration with open chamber and fan-assi-
sted circulation (type B23) for indoor installa-
tion (see figure above).
The previously-described cover kit is used.
By removing the cap in the upper part of the sealed chamber
and using a relevant diaphragm (3) to cover the intake hole.
Combustion air intake takes place directly in the room in
which the boiler is installed.
Flue exhaust takes place through the specific pipes with diame-
ter of 80 in an individual flue or directly to the outside.
B A
3
1
2