7.2 Adjusting the start address
For operating the unit with a light controller, adjust
the DMX start address for the first DMX channel of
the light effect unit. The following DMX channels
are then automatically assigned to the following
addresses. (For example, for start address 5 the
channels 2 to 6 are assigned to the addresses 6 to
10, address 11 would then be the next possible free
start address for the following DMX-controlled unit.)
Press the button MODE (1) so many times until the
display (3) shows the last address adjusted, e. g.
. Then adjust the address with the button UP
or DOWN (4).
After adjusting the start address, the light effect
unit can be operated via the DMX controller. The
reception of control signals will be indicated by a
flashing point on the display.
7.3 Motor positioning
For motor positioning via the first DMX channel
(DMX value 0 – 100
table, fig. 5) the control
direction may be reversed, the rotation of the motor
will then be opposite. Press the button FUNC (2) so
many times until
(normal control) or
(reverse control) is shown on the display (3), then
switch between both adjustments with the button
UP or DOWN (4).
8
Display of the firmware version
To indicate the present version of the firmware
(operating system of the light effect unit), press the
button FUNC (2) so many times until the display (3)
shows the version number (e. g.
).
9
Cleaning the Unit
The lenses should be cleaned at regular intervals,
depending on impurities caused by dust, smoke or
other particles. Only this will ensure that the light is
radiated at maximum brightness.
For cleaning,
disconnect the mains plug from the socket.
Only use a soft, clean cloth and a detergent for
glass.
For cleaning the other parts of the housing, only
use a soft, clean cloth. Never use any fluid; it may
leak into the unit and cause damage.
10 Specifications
Power supply: . . . . . 230 V~ / 50 Hz
Power consumption: 30 VA
Illuminant: . . . . . . . . 3 super bright 3 W LEDs
(1 × red, 1 × green, 1 × blue)
Ambient
temperature: . . . . . . 0 – 40 °C
Dimensions, weight:
LED-102RGB: . . .
∅
28 × 33 cm, 4.5 kg
LED-122RGB: . . . 30 × 20 × 27 cm, 3.9 kg
Subject to technical modification.
11
GB
All rights reserved by MONACOR
®
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual
may be reproduced in any form or by any means for any commercial use.
