IMC CAEMAX DX, Руководство пользователя

Страница: 30 / 92

D
x
Telemetry System
Manual Vers. 2.7
30
/
92
3.6.4 Configure Full Bridges / Half Bridges
Make sure the desired channel has been assigned the correct signal mode
(see section 3.6.1).
Open the desired channel by selecting
Channels→Channel X.
3.6.4.1 Calibration
In the Calibration section, enter a two-point calibration line in the fields Sample 1 and
Sample 2. Define physical unit of output in the Units field.
When configuring with a web browser, confirm your input with the Set button to resume it to
the D
X
.
3.6.4.2 Autozero
Check the Autozero box to select the channel for zero adjustment in measuring mode.
When configuring with a web browser, confirm your input with the
Set button to resume it to
the D
X
.
Please note: Zero adjustment is permanently stored in the D
X
and is reloaded when the
system is restarted.
3.6.4.3 Measurement Range
Enter upper and lower bound of desired measurement range in the fields Range min: and
Range max. The measurement range resolution is 16 bits.
Please note: The measurement range can be increased/decreased by powers of two and is
centered on zero.
When configuring with a web browser, confirm your input with the
Set button to resume it to
the D
X
.
Select Program .
Please note: Make sure the SCT is switched on (i.e. supplied with power) and radio
transmission from RCI to SCT is undisturbed. Otherwise, the SCT can’t be programmed
successfully.
Confirm the message
.