IKA 10 basic, Руководство по эксплуатации

Страница: 15 / 48

15
Error codes
IKA
®
Roller 6/10 basic
In case of a fault, a beep is heard and the “Power” LED flashes.
Proceed as follows in such cases:
1. Switch the device off.
2. Perform corrective measures as described below.
3. Perform a restart.
Error Cause Effect Solution
Motor blockage or overload Motor off • Switch the device off.
• Reduce the load on the motor and check all moving parts for
freedom of movement.
• Then perform a restart.
If the actions described fail to resolve the fault or another error code is displayed then take one of the following steps:
• Contact the IKA ® service department,
• Send the device for repair, including a short description of the fault.
IKA
®
Roller 6/10 digital
The fault is shown by an error code in the display as following if the error occurs, e.g. Er 4.
Proceed as follows in such cases:
1. Switch the device off.
2. Perform corrective measures as described below.
3. Perform a restart.
Error Cause Effect Solution
Er 3 Temperature inside device is too
high
Motor off • Switch the device off.
• Allow the device to cool down.
Er 4 Motor blockage or overload Motor off • Switch the device off.
• Reduce the load on the motor and check all moving parts for
freedom of movement.
• Then perform a restart.
If the actions described fail to resolve the fault or another error code is displayed then take one of the following steps:
• Contact the IKA ® service department,
• Send the device for repair, including a short description of the fault.
Spare parts order
When ordering spare parts, please give:
• Machine type
• Manufacturing number, see type plate
• Item and designation of the spare part, see www.ika.com ,
spare parts diagram and spare parts list
Repair
In case of repair the device has to be cleaned and free
from any materials which may constitute a health ha-
zard.
For this you should use the downloaded print of the " Certificate
of compliance " form from the IKA
®
website www.ika.com .
If you require servicing, return the appliance in its original pa-
ckaging. Storage packaging is not sufficient. Please also use sui-
table transport packaging.
The device operates maintenance-free.
For cleaning disconnect the main plug.
• Wear protective gloves when cleaning the devices.
• Do not place electrical appliances into the cleaning agents
for cleaning purposes.
• Do not allow moisture to get into the appliance when
cleaning.
• Please consult with IKA ® before using any cleaning or de-
contamination methods, other than those recommended
here.
Only clean IKA
®
appliances using these IKA
®
approved cleaning
agents:
Dirt Cleaning agent
Dyes isopropanol
Building materials water containing detergent,
isopropanol
Cosmetics water containing detergent,
isopropanol
Food water containing detergent
Fuels water containing detergent
Other materials please consult IKA ®
Maintenance and cleaning