Igloo INNOVA T 74, Руководство пользователя

Страница: 23 / 49

en
23
User manual INNOVA T www.igloo.pl
(Applies to therm. „IGLOO”) The device is working, the sound signaling is on... - Make sure that:
• The condenser is not contaminated, clean if necessary
• The condenser fan works
• Ambient temperature is not higher than 25ºC
The device is working too loud...– Make sure that:
• The device is standing stably and is properly levelled
• Furniture adjoining the device do not vibrate when the cooling aggregate compressor is working
The unit is working, the frame does not rotate...- Make sure that:\
• The frame rotation switch is in the ON position
• The cabinet doors are closed
6.2. Service
IGLOO service telephone number: +48 (14) 662 19 56 or +48 605 606 071 e-mail: serwis@igloo.pl
If after checking points described in chapter 6.1 “Fault identification and repair” the device still does not work
properly, please contact Technical Service of the Igloo company, stating the data from the data plate Fig.13 (p.10)
• Serial number (NS)
• Production date
• Type (name of the device)
and
• Date when the device was purchased
• Description of the problem
• Your exact address and telephone number
(with the code number)
• The data plate is located inside the device, on the screen, in its right upper corner
The sound produced by the working device is a normal phenomenon. The equipment includes
fans, motors and compressors, which turn on and off automatically. Every compressor produces a
noise while at work.
These sounds are made by the engine of the chiller unit and by the refri -
gerant flowing in the circuit. This phenomenon is a technical characteristic of refrigeration
units and does not mean malfunction.
In the case of exceeding the ambient conditions as per third-class climate (relative humidity above
60%), the phenomenon of water transfer from the system with automatic condensate evaporation
(evaporator) may be observed. This case does not mean malfunction and does not require calling
maintenance.
The condensation on the glass panes at high humidity above 60% is natural and does not require
calling maintenance!
L0 & HI – Displaying these alarms may be caused by incorrect parameters of the power supply. The
alarm can be reset by turning off the main switch. Turn on the device again after a moment. If the
problem persists (the alarm is displayed again), call an authorized service!
The above figure shows a demonstrative data plate and the data stated on the plate are exemplary
data, which are not related with INNOVA T device!