O3M area surveillance
48
Error code
Description
240
O3M ERROR
Emergency mode with unknown error cause
241
O3M ERROR
O3M in op_fault_super_state mode
242
O3M ERROR
O3M in op_safe_lock mode
251
O3M ERROR
The O3M device information cannot be read� The
diagnostic protocol UDS is blocked by another CAN
member (e.g. ifm Vision Assistant).
253
O3M ERROR
Parameter setting after setting OnP takes too long
(T>=500ms).
254
O3M ERROR
Timeout: The connection to the O3M was lost�
11.5 Error codes BasicController
The following error codes are used by the BasicController:
Error code
Description
126
Device is incompatible
The device is disabled due to incompatible O3M Rcv
lib�
127
Device is incompatible
The device is disabled due to incompatible
ApplSetCom lib�
241
Device error
Violation of the device library� An unknown O3M
version was used when initialising the stock FRAM�
►
Contact ifm support
242
Device error
Violation of the device library� No default FRAM
content has been defined�
►
Contact ifm support
248
Device error
The O3M device information cannot be read�
UDS blocked by another member (e�g� ifm Vision
Assistant).
249
Device error
Unable to assign an address to the device, no
device information available�
►
Contact ifm support
250
Device error
Unable to assign an address to the device, unknown
device type, the device name cannot be set�
►
Contact ifm support
251
Device error
No address can be assigned to the device� The
address assignment cannot access CAN_TX�
►
Contact ifm support
252
Device error
The address assignment has failed� The preferred
source address is occupied�
►
Check the bus member for address conflict
253
Device error
The address assignment has failed� An identical
device name was transmitted�
►
Contact ifm support
254
Device error
TIMEOUT, connection to device lost�
255
Device error
CAN BUSOFF or CAN initialisation failed�
►
Check CAN wiring, CAN baud rate�