iFire CRM 43, Руководство по установке

Страница: 6 / 12

Photo 1: Signs of Burner Safety
▪ Use only the provided tool to move the shutter since it is very warm and there is danger of burning in case of
barehanded contact.
▪ If the flame does not turn off completely when having moved the shutter to its closed position, move it back again to its
open one and try again to turn it off drawing the shutter with a faster and more abrupt move this time.
▪ There is the possibility after a long-term use the lid to be dilated as a result the shutter not to move normally. Knock the
edge of the burner with a butt and careful bump with the moving tool of the shutter. Be careful not to cause any damage
to the burner.
▪ If after quenching remains any fuel into the burner, keep the lid closed so as to prevent its vaporization. When you want to
use it again, fill the burner with fuel till MAX and then turn it on again.
Burning Time
▪The burner, depending on the model, has a certain fuel capacity (maximum capacity).
▪Among the technical characteristics of each model, there is the maximum burning time that refers to the burning of full
burner in a completely open position of the shutter (max. flame).
▪To save more fuel and extend burning time you can reduce the burning hole (lower flame) using the special tool.
Safety Instructions
The burner has on the surface of the filling opening a visible and permanent symbol to indicate that the filling is not allowed
during the function when the burner is in hot condition.
Maintenance Instructions
ATTENTION! The burner is getting hot during its function. After the quenching the burner remains warm. Leave it at
least 30 minutes for the natural cooling before you touch it barehanded.
Clean the surface of the burner only after the burner has been cold enough.
ATTENTION! The cleaning and the maintenance of the device must not be preformed by unsupervised children.
▪Do not use harsh cleaning or cleaning in powder because it can cause damage on the surface of the burner.
▪To avoid fuel leakage make sure that it is empty of fuel before cleaning.
▪For the burner’s cleaning use fresh cloth. Use only water and if needed soft cleaning liquid (like for dishes).
For tough stains or dull of the surface wipe with spirit.
▪Before using the burner again make sure that you have placed again properly all its parts.
▪Regular check of all the obvious parts of the burner must be done for damages. In case of damage replace the damaged.
▪If any problem happens during its function, contact with the manufacturer or the supplier for assistance.
Facing Problems
Problem Possible Cause Action
There is smoke
or a strange
odor that comes
from the burner
when being in
function
A. There might be other elements that are burning in the burn-
er.
B. Use of wrong fuel (it’s imperative that you use ONLY fuels
with ethanol base).
C. Have placed something around or on top of the flame that is
not approved or not suggested.
D. If the burner is empty (the flame is turning off) or if you have
just turned off the flame, this is normal. Exactly as happening
when you turn off a candle.
E. The ethanol quality you ’re using is not good
enough.
▪ Turn off the burner and wait
until it gets cold.
▪ Clean the burner and remove
other elements.
▪ Contact with the manufacturer
/supplier for proposals of
appropriate/suggested fuels.
5